Note: The following information applies to the IS-SW1.1 Smartwatch.
Attention: only activate developer mode if you are a programmer or if you have programming experience. Incorrect handling can destroy the device.
 | Press the Power key (2) to enter the menu |
 | Open <Settings> |
 | Select <About Device> |
 | Tap the <SN NO.> button 10 - 20 times |
 | Press the side key right (3) once to go back one step in the menu |
 | Long press on <Settings> |
Debug mode is active, now you can use ADB as usual, for example.